Sandia Remote Mount Transponder - Mode C

Sandia STX 165R Remote Mode-C Transponder and Harness

Sandia STX 165R Remote TransponderWith the STX 165R from Sandia Aerospace you can take your transponder out of the panel, and mount it closer to the antenna. You can control the transponder (change modes, squawk and Ident) directly from your iEFIS, Odyssey/Voyager or XTreme EFIS. Only 4 wires to connect - Power/Ground/RS-232 RX/RS-232 TX. Coax required with SMA connector for Sandia (BNC on the antenna side).

        Qty: STX 165R - $1,550.

        Qty: Harness available (schematic) - $65.

        Qty: Terminated Coax Cable for Sandia (1 SMA and 1 BNC)

        Qty: DPA Transponder Antenna, streamlined, non-TSO, $69.


uAvionix EchoUAT ADS-B IN/OUT 2020-Compliant Package

echoUAT uavionixuAvionix EchoUAT ADS-B IN/OUT

uAvionix-Logo-REV-D-BigWith the EchoUAT ADS-B in/out transceiver and the STX 165R Mode-C from Sandia Aerospace you can be 100% 2020-compliant right now when flying below 18,000’ (Mode-S required above 18,000’). The Sandia transponder satisfies the ongoing requirement for a transponder, and the EchoUAT includes ADS-B IN and OUT as well as a compliant GPS. The MGL EFIS controls the Sandia transponder and the Sandia transponder controls the EchoUATx. The EchoUAT has an RS-232 output to send traffic and weather to the iEFIS, and also a Wifi antenna to send this data to an iPad or other Wifi-enabled device. Wiring and Setup instructions are here.

        Qty: EchoUAT and SkyFYX EXT Bundle - $1,398.

        echo-uatskyfyx-ext ads-b

        EchoUAT and SkyFYX Bundle includes:

            echoUAT ADS-B Transceiver
            wiring harness
            UAT (978) antenna
            SkyFYX-EXT All-in-One GPS Receiver and Antenna

        Qty: Coax Cable
        for Sandia/EchoUAT (1 SMA and 1 BNC)

See EchoUAT wiring and setup instructions here.



Trig Remote Mount Transponder - Mode S

Trig TT22 Remote Mode-S Transponder and Harness

Trig TT22 Remote Mode-S TransponderThe TT22 Class 1 Remote Mode-S transponder with Extended Squitter is ADS-B OUT ready for 2020 (requires SP-12 ADS-B-Compliant GPS). It is a remote unit that is controlled via the iEFIS (all models of the iEFIS/Lite). It connects via the CAN bus so it does not use up any RS-232 ports. The MGL/Trig Interface is required and the coax has a TNC connector on one end (BNC on the antenna side).

        Qty: TT22 Remote Transponder - $2,200.

        Qty: Trig Interface (manual) - $190.

        Qty: Terminated Coax Cable for Trig (1 TNC and 1 BNC)

        Qty: DPA Transponder Antenna, streamlined, non-TSO, $69.

        Qty: MGL SP-12 Compliant GPS, with antenna (manual), $359.

        Qty: SP-12 Harness (schematic), $95.